Hello, I tried Race Chrono on another phone (Galaxy S5). I was unable to enter a channel! PID "enter a valid PID value" I type 599, it's transformed into 0x 02 57 but it's invalid I can enter some values like 0500 but no way to put 0599
@Marcus54 You're trying to add a OBD-II channel. OBD-II PIDs need to start with 0x22 or 0x01. This is a safety feature, not to mess with writeable PIDs. I believe you wanted to add a CAN-Bus channel right?
Hello, For disconnection from time to time I tried on an old phone (Samsung S5) I only installed RaceChrono.
With this method I haven't had a disconnection yet. I have not activated the ODBlink channels, only the CAN BUS. It works fine except that I have permanently the error message at the bottom of the screen "Connecting to OBDLink LX). Is it possible to disable this error message?
The CAN/OBD vs GPS auto-synchronization is awesome!
It's unclear what's the difference between "Session start"/"Session resume X" and "Whole session". In my case, even when I use "Session resume", the adjustment only applies to the laps between the previous start/resume and the next resume. Did you intend "Whole session" to mean "All laps"? In that case, there might be a bug; and "All laps" would be a clearer name.
@Marcus54 it's done, now testing. Beta version for Android should be out next week, and the production versions for both platforms as soon as it's sufficiently tested
Comments
Bus CAN : 45 24 E7 B2 23 F7 05 FC
in Little endian octet
FC 05 F7 23 B2 E7 24 45
0010 1110 0111 0010 0100 0100 0101 = 48702533 = 48.70° OK
I tried Race Chrono on another phone (Galaxy S5).
I was unable to enter a channel!
PID "enter a valid PID value" I type 599, it's transformed into 0x 02 57 but it's invalid I can enter some values like 0500 but no way to put 0599
I had not activated CAN BUS, so with the importation of the vehicle I have everything.
For disconnection from time to time I tried on an old phone (Samsung S5) I only installed RaceChrono.
With this method I haven't had a disconnection yet.
I have not activated the ODBlink channels, only the CAN BUS.
It works fine except that I have permanently the error message at the bottom of the screen "Connecting to OBDLink LX).
Is it possible to disable this error message?
I will test tomorrow...
It's unclear what's the difference between "Session start"/"Session resume X" and "Whole session". In my case, even when I use "Session resume", the adjustment only applies to the laps between the previous start/resume and the next resume. Did you intend "Whole session" to mean "All laps"? In that case, there might be a bug; and "All laps" would be a clearer name.
When will we have version 7.2
Thank you